Mini Modular NAND

I have been thinking about the NAND synth and giving it some additional capabilities.  This is my plan for a mini modular based on the 4093 NAND.  Each of the four NAND gates would be made into a separate oscillator.  Each oscillator would have three switches three knobs/pots and three jacks.

Switch 1 On/Gate: Determines if it is on all the time or if it can be controlled by the gate input.
Switch 2 Square/Saw: Switches a capacitor on the Cv input (I need to add this cap to the circuit shown above.)
Switch 3 VCO/LFO: Switches the feed back to a larger capacitor to make it into an LFO.
Knob 1 Pitch
Knob 2 Volume
Knob 3 Modulation amount (pitch)
Jack 1 Gate input
Jack 2 Cv Input
Jack 3 Output

This is the basic schematic for this.  Assume the gate starts in state Hi Lo then the 1n cap charges until it goes Hi at which point the output goes Lo.  The rate of charge and discharge is controlled by the pitch pot or by the transistor depending on the base current.  The LED monitors the output and turns on or off based on the output.  The LFO switches in a larger capacitor so it takes longer to charge.  The wave shape applies a low pass to the input signal.  I may have made some mistakes in this drawing but this is basically how it works.

This basic structure is repeated four times.

Next comes the filter which I described in a previous blog.  This consists of three simple resonant low pass filters and a clipping op amp differentiator.

This one does not have the voltage control transistor in it yet so I am still working on that.  It also shows a QF connection on filter 2 which should be bypassed.  The way this filter works is to have both a resonant low pass (with assymetry switch) and a low pass (Q turned all the way down).  Then subtract the two signals and clip them with the op amp.  This creates a complex waveform (supposedly).  Finally feed the result out through the final filter with resonance.  Need to add an additional input for external signals as well as transistors so I can modulate the cut off frequency.  The filter will from the base of the module.

RS is a rail splitter.